Specifications

C•CURE apC/L Technical Manual
apC/L Panel Setup
6-4
Setting the apC/L Switches
The bottom of the apC/L has one switch package labeled SW3 and a rotary
switch labeled SW1. (See Figure 6.2.)
Figure 6.2 SW3 and SW1 Switches
Use rotary switch SW1 to indicate the apC/L’s unique address. You can set the
SW1 rotary switch by using a screwdriver to turn the arrow to the number you
want. You need to set SW3:8 correctly to indicate the address.
The SW3 DIP switch package contains eight switches with two positions: ON
(or closed) and OFF (or open). For most installations, all switches should be
in the OFF position.
The apC/L reads the SW3:2 switch (dialup mode enable) only when it is
powered up with the SW3:1 switch set ON. Changes to the SW3:2 switch
setting do not take effect until the next power up with SW3:1 set ON.
Table 6.1 lists the settings for the apC/L DIP switches. The following sections
describe the switches and their function.
RESET
SW1
SW3
ON
apcl.bk Page 4 Monday, May 15, 2000 3:21 PM