Specifications

C•CURE apC/L Technical Manual
Input and Output Modules
5-6
Installing Optional Modules
You install the optional modules on the reader bus, just as you would
install a reader. The mounting slot in each corner serves as a connection
for earth ground. For ESD considerations, make sure at least one corner is
tied to earth ground.
Input/Output Number Map
Numbering for inputs and outputs differs depending on which C•CURE
system you are using. For a numbering map of these inputs and outputs,
see Appendix E of this manual.
Every input device, including door contacts, request-to-exit, or standard
monitoring equipment, has a unique input number determined by the
Input module pins to which it connects. Input pins are located on the RM
personality module and the Input Module.
Setting Up Input/Output Module Addresses
For each Input or Output Module you use, you must configure an address.
Different types of modules can have the same address, but the same type
of module cannot have the same address.
Table 5.1 indicates how to set up addresses for the modules. Note that
each device has a unique address from 1 to 4, and that an RM’s address
maps to the physical number of the module.
Table 5.1 Available Address for RM Modules
Device Type Device Address
RM Reader 1 2 - -
InputModule 1234
OutputModule1234
apcl.bk Page 6 Monday, May 15, 2000 3:21 PM