Specifications

C•CURE apC/L Technical Manual
The I8 Input Module
5-3
The I8 Input Module
The apC/L I8 (also referred to as an RM Input Module), provides eight
Class A supervised inputs. You can connect a total of four Input Modules
to one apC/L. Input Modules connect directly to the RS-485 reader bus,
which reduces wiring.
Figure 5.2 shows the layout of an Input Module.
Figure 5.2 apC/L Input Module
All input switches can be located up to 2,000 ft. (609.6 meters) from the
Input Module. Use twisted 18 AWG (0.902 mm) Belden #8461 or twisted
22 AWG (0.357) Belden #8442 to connect the input switches to the input
pins.
If the unit is “last in line,” put in jumper W1. If the unit is not “last in
line,” put in jumper W1 or one or the pins.
Input connector
1/8" hole
(3.2 mm)
SW1 Address
switch
Port
connector
SW1
R61
R62
R63
R64
P1
P2
P3
P4
P9
P8
P7
P6
P5
R68
R67
R66
R65
1234
W1
Tamper
Input
3.93"
5.31"
(13.45 cm)
(9.98 cm)
W1
apcl.bk Page 3 Monday, May 15, 2000 3:21 PM