Specifications

C•CURE apC/L Technical Manual
Wiring Card Readers
4-10
Setting SW1 to 9 starts a test program when the reader is turned on. This
test is explained in Chapter 7.
Table 4.2 SW3 Reader Configuration Switch Settings
This Switch... Controls... When OFF (Open) When ON (Closed)
SW3-1 Reader type Magnetic stripe Wiegand/proximity
SW3-2* LCD Present (RM2L only) You do not have an LCD
display
SW3-3: Set this switch
ON when using
external reader heads
which have bi-colored
LED’s. Wire the green
control wire to the
green LED (J4-4) and
the red control to the
red LED (J4-2).
LED option Normal External bi-color
SW3-4 Tamper switch Enabled Disabled
SW3-5 End of line
terminator
Notlast Lastunitinline
apcl.bk Page 10 Monday, May 15, 2000 3:21 PM