Specifications

C•CURE apC/L Technical Manual
Configuring OEM Modems
F-4
Table F.2 Jumper Settings for Dialup
Switch Default
Setting
Description
W1 Open Open for both reader Port A and Port B, Closed For Either Port A or
Port B.
W2 B 27C512 for 2 Mbyte Flash/EPROM (Set to A for 4 Mbyte Flash/
EPROM).
W3 OUT 128K X 8 SRAM (10K OR 20K) (Set to IN for 512K x 8SRAM (40K
OR 80K).
W4 IN Last Unit in RS485 chain. (OUT for Not last RS485 unit in chain).
W5 IN Last Unit in RS485 chain. (OUT for Not last RS485 unit in chain).
W6 OUT Cabinet tamper enabled (IN for cabinet taper disabled).
W7 A Normal, B is for internal use only.
W8 IN Internal Power Fail
W9 B Host is RS232 (A is RS485).
W10 B Host is RS232 (A is RS485).
W11 B Host is RS232 (A is RS485).
W12 B Host is RS232 (A is RS485).
W13 B Host is RS232 (A is RS485).
W14 B Host is RS232 (A is RS485).
**NOTE**These are basic panel settings and may require changes to meet your site-specific
needs.
apcl.bk Page 4 Monday, May 15, 2000 3:21 PM