Instruction manual

Page 2
Notice:
The information contained in this document is subject to change without notice.
GE makes no warranty of any kind with regard to this material, including, but not limited to, the
implied warranties of merchantability and fitness for a particular purpose. GE shall not be liable
for errors contained herein or incidental consequential damages in connection with the furnishing,
performance, or use of this material.
This document contains proprietary information, which is protected by copyright. All rights are
reserved. No part of this document may be photocopied or otherwise reproduced without consent
of GE.
Copyright (c) 1998 by GE
Published in a limited copyright sense, and all rights, including trade secrets, are reserved.
Document Edition - First 10/98
kV™, MeterMate™, and OPTOCOM™ are trademarks of GE.
MS-DOS and Windows are a trademark of Microsoft Corporation.
FCC Notice
FCC Part 15: Preventing Radio and Television Interference
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause
undesirable operation.
Changes or modifications to this equipment not expressly approved by the General Electric
Company could void the user’s authority to operate this equipment.
This instruction book does not cover all details or variations in equipment nor provide for every
possible contingency to be met in connection with installation, operation, or maintenance. The
equipment covered by these instructions should be operated and serviced only by competent
technicians familiar with good safety practices, and these instructions are written for such
personnel and are not intended as a substitute for adequate training and experience in safe
procedures for this type of equipment. Should further information be desired, or should particular
problems arise which are not covered sufficiently for the purchaser’s purpose, the matter should
be referred to GE Meter.
Warning
Any work on or near energized meters, meter sockets, or other metering equipment can
present a danger of electrical shock. All work should be performed only by qualified
industrial electricians and metering specialists in accordance with local utility safety
practices and the procedures outlined in the Handbook for Electricity Metering, Chapter
14 (available from Edison Electric Institute, 1111 19th Street NW, Washington, DC 20036).
The information contained in this instruction book is intended to be an aid to qualified
metering personnel. It is not intended to replace the extensive training necessary to
install or remove meters from service.