Instruction manual

Page 18
connection and carrier detected. By
monitoring this LED (as well as any LEDs on
the external modem), correct operation of
the kV RSX, can be verified during meter
installation.
Renewal Parts
kV RSX Kits
There are four (4) kV RSX kits that may be
ordered to retrofit a “Modem ready” kV™
Meter. “Modem ready” kV™ Meters will have
“Modem Ready” printed on the meter
nameplate. If the kV™ Meter nameplate
does not have this designation, the meter
can not be retrofitted with a kV RSX board.
S-Base kV RSX Kits
If a communications cable with a DB-9
connector is desired, order GE part number
9938627001. This kit contains the following
material:
Component GE Part # Qty
kV RSX circuit
board
9938498003 1
Cable assembly 9938583001 1
Connector holder 9938622001 1
PC board
spacers
9935026005 4
Wire tie 9689597010 1
Instruction sheet GEI-101424 1
If a communications cable with an RJ-11
connector is desired, order GE part number
9938627002. This kit contains the following
material:
Component GE Part # Qty
kV RSX circuit
board
9938498003 1
Cable assembly 9938583002 1
Connector holder 9938622001 1
PC board
spacers
9935026005 4
Wire tie 9689597010 1
Instruction sheet GEI-101424 1
A-base kV RSX Kits
If a communications cable with a DB-9
connector is desired, order GE part number
9938627003. This kit contains the following
material:
Component GE Part # Qty
kV RSX circuit
board
9938498003 1
Cable assembly 9938583003 1
Connector holder 9938622001 1
PC board
spacers
9935026005 4
Instruction sheet GEI-101424 1
If a communications cable with an RJ-11
connector is desired, order GE part number
938627004. This kit contains the following
material:
Component GE Part # Qty
kV RSX circuit
board
9938498003 1
Cable assembly 9938583004 1
Connector holder 9938622001 1
PC board
spacers
9935026005 4
Instruction sheet GEI-101424 1
Note:
When the kV™ Meter is first
energized at the installation site, the carrier
detect LED will illuminate to indicate that
the kV RSX is properly powered. After the
kV RSX is initialized, the carrier detect LED
will go out. If the LED stays illuminated for
more than 5 seconds, the kV RSX board is
defective and should be replaced.