Instruction manual

Page 15
Figure 13 : Battery cover installation
Option Board Compatibility
Introduction
The kV™ RSX Option Board may be used in
conjunction with the RG-1 Revenue Guard,
I/O-2 Input/Output, and the LP-2 Load Profile
option boards. In cannot be used with either
the I/O-1 Input/Output, the LP-1 Load Profile
option boards or the kV Internal modem
board. The RSX is used in lieu of the kV
Internal Modem board.
The kV™ RSX Option Board is always
installed directly onto the kV™ Meter. Either
the I/O-2 Input/Output or the LP-2 Load
Profile option board may then connect to the
kV™ RSX Option Board if desired. If all
three option boards are used, the option
boards must be installed in the following
order:
1. kV™ RSX Option Board
2. LP-2 Load Profile option board
3. I/O-2 Input/Output option board
RG-1 Revenue Guard Option
Board
The RG-1 Revenue Guard option board may
be used in conjunction with any other kV™
Meter option board including the kV™ RSX
Option Board.
I/O-1 Input/Output Option Board
(Obsolete)
The I/O-1 Input/Output option board (GE part
# 9938226002) is now obsolete and has been
replaced by the I/O-2 Input/Output option
board (GE part # 9938226004). The I/O-1
option board cannot be used with the kV™
RSX Option Board. If I/O is needed in a kV™
Meter with a modem, the I/O-2 option board
must be used. See Table 1: I/O-1
Compatibility for more details.
I/O-1 LP-1 LP-2 kV RSX
√
√ √
√ √
Table 1: I/O-1 Compatibility