Specifications

Cylinder Bracketing Installation
Zero Turn Mowers
Recommended
Propane Cylinders
33.5LB and 45.5LB vapor service horizontal cylinder, or 33.5LB and 43.5LB in vertical position
with vapor service valve installed
Tank Fitting
and Lines
Left hand ACME
Bracketing
33LB horizontal cylinder bracket. Part AF1-33LB
Installation on
Application
Option 1: Remove gasoline tank and extend bases to accommodate 33LB bracket.
Option 2: Mount horizontally to rear of Roll-Over Protective Structure. Be sure to mount in an
area that allows you to lower and raise the ROPS.
Option 3: Mount vertically to rear or side of Roll-Over Protective Structure.
Materials needed
AF1-33LB bracket use (4)- ¼ inch plate steel by 36 inch wide by 8 inch tall.3/8x3”boltsandlock
washers and nuts. Or use (4)- 3/8”UPbolts3”x3”tosecure AF1-33LBtoplate.Usea16”outside
to outside pattern. Use (4) -3/8”x1”bolts,lockwashersandnuts.Alsosecurethetankguidepin
tobottomoftankbracketforproperlocationoftankvalvewith3/8”boltssupplied.This
bracketing will allow the tank to be secured to roll bar applications. For fender mounts a piece of
¼”platesteelby20”longby10”widewillsecureittotheframeorfenderoftheunit.
Commercial Walk Behind Mowers
Recommended
Propane Cylinders
20LB Aluminum/Steel Cylinder or 14LB Cylinder
Tank Fitting
and Lines
Right Hand ACME
Bracketing
20LB Vertical Cylinder Bracket. Part AF1-20LB
Installation on
Application
Remove gasoline tank and bolt to the base plate of removed gasoline tank.
Materials needed
(4)- 3/8”x3” bolts and lock washers and nuts. Or use (4)- 3/8”Ubolts3”x3”.Mayneed¼”
plate steel
Push Mowers
Recommended
Propane Cylinders
1LB Cylinder (Short Fat) or 5LB Cylinder
Tank Fitting
and Lines
1LB direct mount to Regulator System. 5LB uses AF1-120-24
Bracketing
5LB Cylinder Bracket. Part AF1-901 or AF1-120-24
Bracketing Notes
Remove pin from bracket. Place collar of 5LB cylinder over plastic bushings. Push pin through
hole in cylinder collar and over bracket between plastic bushings.
Installation on
Application
Clamp 5LB Cylinder Bracket to handlebars.
Materials needed
None
Putting Green Mowers
Recommended
Propane Cylinders
1LB Cylinder (short fat) or 5LB Cylinder
Tank Fitting
and Lines
1LB direct mount to Regulator System. 5LB uses AF1-120-24
Bracketing
1LB direct mount to Regulator System. 5LB uses AF1-120-24
Bracketing Notes
Remove pin from bracket. Place collar of 5LB cylinder over plastic bushings. Push pin through
hole in cylinder collar and over bracket between plastic bushings.
Installation on
Application
Clamp 5LB Cylinder Bracket to handlebars.