Specifications

Mounting of AF-2 Regulation System
The following template is a drawing of the mounting plate of AF-2.
Step 1: Cut out the template
Step 2: Place paper template on a desired location
Step 3: Trace template onto desired location
Step 4: Drill 2 holes in the desired location
Step 5: Mount the AF-2 Conversion system
Additional parts needed:
2 ¼ 28 screws to desired length
Drill
¼ 28 drill bit
Sharpie marker
If your engine is 10hp or higher, the regulation system must be mounted vertically.
If your engine is less than 10hp the regulation system must be mounted horizontally.
TEMPLATE