Specifications

Starting
Engines 3-13hp
Cold Start:
1. Close choke.
2. Throttle half open.
3. FuelControlValve1⁄2turn.
4. Prime 2 seconds.
5. Start.
6. After start and warm up adjust Fuel Control Valve to optimum power setting according to use.
7. If the engine will not start, please repeat the installation that applies to your application.
Do not over-prime. Stop priming when resistance is felt on the primer. Forcing the primer
will damage the regulator and is not covered under warranty.
8. Mark Fuel control Valve setting for reference.
9. If the engine will not start, please repeat the installation instruction that applies to your application.
Do not over-prime the regulator if it is over-primed because the lever within the regulator will break
and ruin the regulator. This is not covered under warranty.
Warm Start:
1. Close the choke.
2. Throttle half open.
*Most engines 3-13hp requires full choke to start and run. Some may require less than full choke for
optimum performance.
**Engine idle may be rough or loop until the components in the Regulator System have had a chance
to break in. This may take up to 20 hours of run time.
Stopping
All Engines
1. Slow engine down to near idle.
2. Turn engine off.
3. If unit is to be stored or transported in an enclosed area or trailer close valve on propane
cylinder(s).
4. Close valve on propane cylinders on any unit that will not be restarted within a few minutes.
5. The Fuel Control Valve on the Regulation System does not need to be closed as long as the
valve(s) on the attached propane cylinders are closed.