User`s manual

Page 9
EC24U3032
Chapter 3: Mounting Instructions
3. Mounting Instructions
3.1 Receiving, Unpacking, and Removing the Elite Wallmount Enclosure from the Pallet
Inspect for damage and report damage if there is damage before receiving. Refer to Section 2.3 for what‘s included
in the package.
Unpack the enclosure by carefully removing the corrugated carton and corners. Avoid damaging the enclosure when removing
packaging.
WARNING: Only trained service personnel should be used to remove the enclosure from the pallet. Also be sure you have a
sufficient number of service personnel. Do not attempt to move enclosures by yourself.
WARNING: Be careful when moving enclosures before installation. Sudden stops and starts, excessive force, obstructed routes,
and uneven floor surfaces may cause the enclosure to topple over.
3.2 Mounting to Wood Stud Walls
Once a location for the cabinet has been selected, inspect the wall and ensure that the wall or other mounting surface has a
structural load capacity that will support the cabinet and the maximum payload. Ensure that the mounting surface extends
beyond the top, bottom, left, and right edges of the rear of the cabinet.
The rear frame must be secured to a wall using the hardware provided. For masonry, or mounting to other surfaces, the installer
must provide the appropriate hardware.
WARNING: Improper handling and use of the Elite Wallmount Enclosure could result in equipment damage, serious injury,
or possible death.
Other Wall Surfaces
For other wall types, the installer must provide appropriate hardware.