User guide

SERVSWITCH DTX5000/5002 USER GUIDE

5. Choose Firmware Management. The Firmware Management Menu will appear.

Figure 4-30. Receiver Firmware Management Menu (upgrade via HTTP)

6. Choose Receiver Flash Upgrade Via HTTP. You will be prompted to enter the URL

for the upgrade file.

7. Enter the URL for the upgrade file using the following syntax:

http://<server ip address>[:server port]/<upgrade file path>

For example:

http://192.168.13.3:8080/RX.dld

NOTE:

If the server is set up on standard port 80, the port information can be omitted.

8. To initiate the file transfer press Enter. The connection to the transmitter will be

dropped.

9. When the transfer has completed, a message will display stating “Firmware update

successful. Resetting Appliance...”

10. The connection to the transmitter will be restored.

NOTE:

If the receiver determines that the upgrade file is invalid, the receiver cancels the upgrade and maintains

the previous firmware version. A message will display indicating that the firmware upgrade has failed.

4.9 Restoring Factory Default Settings

The serial menu enables you to easily restore the factory default settings of both the

receiver and the transmitter. To view a full list of the factory default settings, see “Factory

Default Settings” on page 11.

NOTE:

Restoring factory default settings will also reset network settings. Before restoring factory default settings,

assess whether this is likely to cause conflicts with other devices on the network.

To restore the receiver factory default settings:

1. Activate the serial menu as described in “Accessing the serial menu” on page 42.

2. Choose option 1 to access the receiver menu. If the password option is enabled, you

will be prompted for a password. See “Authentication” on page 52.