User guide

SERVSWITCH DTX5000/5002 USER GUIDE
52
5. Choose Transmitter IP Config. The Transmitter IP Config menu will appear. The old
transmitter IP address is displayed beside menu option 1.
Figure 4-23. Transmitter IP Configuration Menu on the receiver
NOTE:
This screen is available only in Extender Mode.
6. Choose Detect Transmitter Address. The following message will be displayed,
“Directly connect the transmitter and receiver, then power up the transmitter. Press
any key to abort.”
7. Power up the transmitter.
8. The receiver will detect and save the IP address of the connected transmitter.
The
Transmitter IP Configuration Menu will refresh, and the current IP address
of
the connected transmitter will be displayed beside menu option 1.
9. To save your changes and exit the menu, type 0 (zero) and press Enter.
4.7 Authentication
By default, two passwords are required to access the Black Box ServSwitch Extenders via
the serial menu. One password is for access to the serial menus that control the receiver.
The other password is for access to the serial menus that control the transmitter. In both
cases, the default password is “password”.
Authentication for the receiver
You can change the password settings for the receiver through the serial menu via the
Receiver Security Configuration Menu.
To access the Receiver Security Configuration Menu:
1. Activate the serial menu as described in “Accessing the serial menu” on page 42.
2. Choose option 1 to access the receiver menu. If the password option is enabled, you
will be prompted for a password. See
“Authentication” on page 52.
3. Type the password and press Enter. The Receiver Main Menu will appear.