User guide

CHAPTER 4: OPERATIONS
45
5. Choose Transmitter Network Config. The Transmitter Network Configuration Menu
will appear.
Figure 4-12. Transmitter Network Configuration Menu
NOTE:
For option 5, the administrator can configure the Transmitter IP Address as DHCP or Static. Static is the
default configuration.
6. Choose Transmitter IP Address.
7. Type a valid IP address. Press Enter to return to the Transmitter Network
Configuration Menu.
8. Choose Transmitter Netmask.
9. Type a valid Transmitter Netmask. Press Enter to return to the Transmitter Network
Configuration Menu.
10. Choose Transmitter Default Gateway.
11. Type a valid Transmitter Default Gateway. Press Enter to return to the Transmitter
Network Configuration Menu.
12. Type 0 (zero) and press Enter to return to the Network Configuration Menu.
13. If you made a mistake and do not wish to save the changes you made to the network
settings type C and press Enter.
14. To confirm your changes and apply those settings type 0 (zero) and press Enter.
15. A system message will appear that states “Connection to the transmitter is lost”.
Yo u
will be automatically returned to the Appliance Selection Menu screen.
16. Choose option 1 to access the receiver menu. If the password option is enabled, you
will be prompted for a password.
See “Authentication” on page 52.
17. Type the password and press Enter. The Receiver Main Menu will appear.