Specifications

Chapter 5 Managing Units
5.4.3 Enabling Auto Login Mode for a DTX user station
Auto Login Mode enables you to configure a DTX user station to grant any user access to the target computer paired with
that DTX user station, without the need to enter a username or a password.
To enable or disable Auto Login Mode for a DTX user station:
1. Click the Units tab. A list of all units managed by the DTX Control appliance is displayed.
2. Click the DTX user station name for which you require information. The Unit Overview window opens.
3. Under Unit Settings in the side navigation bar, click Modes. The Unit Auto Login/Operating Mode Settings window
opens.
4. In the Unit Auto Login Mode section, choose Disable or Enable.
5. If Auto Login Mode is enabled, select a target computer from the Auto Login Mode Target Computer list-box. This is
the target computer that will be connected during the auto login process.
6. Click Save and then click Close.
5.4.4 Viewing version information
To view version information for a unit:
1. Click the Units tab. A list of all units managed by the DTX Control appliance is displayed.
2. Click the unit name for which you require information. The Unit Overview window opens.
3. Under Unit Settings in the side navigation bar, click Versions. The Unit Version Information window will open,
containing the following information:
• Release - The version release number.
• Application - The application software version.
• Boot - The boot software version.
• FPGA - The FPGA version.
5.4.5 Rebooting a unit
To reboot a unit:
1. Click the Units tab. A list of all units managed by the DTX Control appliance is displayed.
2. Click the unit name for which you require information. The Unit Overview window opens.
3. In the Tools section, click Reboot. The unit reboots to apply any changes.
5.4.6 Setting the Operating Mode for a DTX user station
The DTX Extender system can operate in two modes - Desktop Mode and Extender Mode. The operating mode of a DTX
Extender system can be set through the DTX user station.
Extender Mode is the default factory setting for a DTX Extender system. In Extender Mode, a DTX user station
automatically discovers and connects to its corresponding transmitter on the network. The DTX Control appliance is not
required as part of the system when in Extender Mode.
When in Desktop Mode, a DTX Extender system can be managed and administered through the DTX Control appliance.
Page 36 724-746-5500 | blackbox.com