Specifications

Chapter 5 Managing Units
Adding a single appliance
This procedure is valid for DTX user stations and transmitters.
NOTE: A unit can only be added to the DTX Control database if it is turned on and attached to the network.
To add a single unit that already has an IP address:
1. In a Units - All window containing managed units, click Add. The Add Unit Wizard Welcome Window will open. Click
Next.
2. The Select Add Unit Procedure window will open. Click Add a single unit, then click Next.
3. The Select Unit Type window will open. Select a unit from the product list, then click Next.
4. The Select Address Configuration of Unit window will open. Select Yes, the <Managed Unit Type> does have an
address and type the address of the unit. Click Next.
5. The Search Results window will open. The name and MAC address of the discovered unit will be displayed. Click
Next.
6. The Completed Successfully window will open. To exit the Add Unit Wizard, click Finish.
To add a single unit that does not have an IP address:
1. In a Units - All window containing managed units, click Add. The Add Unit Wizard Welcome Window will open. Click
Next.
2. The Select Add Unit Procedure window will open. Click Add a single unit, then click Next.
3. The Select Unit Type window will open. Select a unit from the product list, then click Next.
4. The Select Address Configuration of Unit window will open. Select No, the <Managed Unit Type> does not have an
address and click Next.
5. The Configure Unit Network Settings window will open.
a. Type the IP address and subnet mask, in standard dot notation (xxx.xxx.xxx.xxx), for the managed unit.
b. Optionally, type a gateway in standard dot notation (xxx.xxx.xxx.xxx).
c. Click Next.
6. The Add Discovered Unit window will open. Select the discovered unit from the list, then click Next.
7. The Completed Successfully window will open. To exit the Add Unit Wizard, click Finish.
5.3.2 Adding units from a range of IP addresses
This procedure is valid for transmitters and DTX user stations.
To add a unit from a range of IP addresses:
1. In a Units - All window containing managed units, click Add. The Add Unit Wizard Welcome Window will open. Click
Next.
2. The Select Add Unit Procedure window will open. Click Discover units within an IP address range, and then click
Next.
3. The Enter IP Address Range window will open.
a. Type the IP address, in standard dot notation (xxx.xxx.xxx.xxx), from which to begin and end the search.
b. Click Next.
724-746-5500 | blackbox.com Page 33