Specifications

ManualsBrandsBlack Box Manualschassis componentsDESKTOP TELCO

©Copyright2008. BlackBoxCorporation.Allrightsreserved   50‐80105BB‐01A0



1000ParkDrive • Lawrence,PA35055‐1018 • 724‐746‐5500 • Fax724‐746‐0746



APRIL 2008

LMC5202A

2-Slot Desktop Chassis (DC) Extended

Temperature

CUSTOMER

SUPPORT

INFORMATION

Order toll-free in the U.S.: 877-877-BBOX (outside U.S. call 724-746-5500)

FREE technical support, 24 hours a day, 7 days a week: Call 724-746-5500 or fax 724-746-0746

Mail order: Black Box Corporation, 1000 Park Drive, Lawrence, PA 15055-1018

Web site: www.blackbox.com • E-mail: info@blackbox.com

Summary of content (6 pages)

PAGE 1
APRIL 2008 LMC5202A 2-Slot Desktop Chassis (DC) Extended Temperature © Copyright 2008. Black Box Corporation. All rights reserved 1000 Park Drive • Lawrence, PA 35055‐1018 50‐80105BB‐01 A0 • 724‐746‐5500 • Fax 724‐746‐0746 CUSTOMER SUPPORT INFORMATION Order toll-free in the U.S.: 877-877-BBOX (outside U.S.
PAGE 2
FCC and Industry Canada RF Interference Statements Class B Digital Device. This equipment has been tested and found to comply with the limits for a Class B computing device pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. However, there is no guarantee that interference will not occur in a particular installation.
PAGE 3
Electrostatic Discharge Precautions Table of Contents Electrostatic discharge (ESD) can cause damage to your add-in modules. Always observe the following precautions when installing or handling an add-in module or any board assembly. FCC and Industry Canada RF Interference Statements ........................................... ii About the 2-Slot Desktop Chassis (DC)...............................................................1 Part Number ...............................................................
PAGE 4
About the 2-Slot Desktop Chassis (DC) Specifications The 2-Slot Desktop Chassis (DC) is a stand-alone, chassis for use with any of the High Density Media Converter II modules. As an unmanaged chassis, the 2-Slot Desktop Chassis (DC) supports two single-wide or one dual-wide High Density Media Converter II Module. All High Density Media Converter II modules, with the exception of the SNMP management card, will function properly in this chassis.
PAGE 5
DC Power Supply Precautions The following precautions must be observed when installing the chassis model with an internal DC power supply. 1. 2. Check nameplate ratings to ensure there is no overloading of supply circuits that could effect over current protection and supply wiring. In addition, the following must be observed: a. Connect the equipment to a 35 to 60 VDC power source that is electrically isolated from the alternating current source. b.
PAGE 6
Configuring and Installing Modules Black Box recommends turning the chassis power off before proceeding. 1. To install a High Density Media Converter II module, slide the module into the chassis until the module is firmly seated in the backplane. 2. Secure the module to the chassis by tightening the captive thumb screw on the High Density Media Converter II module. 3. Attach the network cables between the High Density Media Converter II module and other devices that will be interconnected. 4.