Specifications

Basic Operation (ADD-ON MODE)
Key Finder
Control Unit
5/∞/2/3 buttons
POWER button
Buttons 1–6
DISPLAY button
BAND button
MODE button
Basic Operation of XM
When using this product for the first time, refer to “FM Modulator Setting” to set the FM
frequency and volume appropriately.
1. Switch to an FM source on your car stereo and tune to the frequency set in
“FM Modulator Setting”.
2. Switching power ON.
3. Select a desired Channel.
Note:
• For details, refer to “Selecting the Channel by Channel Number”.
4. Switching power OFF.
Note:
• If it is hard to hear the output sound, it may be due to interference from a strong FM broadcast. Refer
to “FM Modulator Setting”, and change the setting.
• Even if you switch this product OFF, the FM car stereo remains switched ON.
• When not listening to an XM broadcast, switch this product OFF. Leaving it switched ON reduces
the sensitivity of your car radio.
• Display changes as follows when you switch Channels or operate in other ways.
Channel Number = Channel Name = Selected Display *
* For details, refer to “Switching the Display”.
•
It may take a few seconds before you can hear anything wile this product acquires and processes the
satellite signal when you switch power ON, change the Source to XM tuner, or select a Channel.
Recalling Preset Channels
7 Direct Recall
• Press a button from 1–6 to recall a Channel preset in the button.
(e.g. Press button 4.)
7 Sequential Recall
When Channel Number Select mode is selected, you can use the sequential recall. (Refer to
“Switching the Channel Select Mode”.)
• Recall Channels preset in buttons 1–6 in sequence.
Note:
• If a Channel you have recalled cannot be selected, a message is displayed for 2 seconds and the unit
returns to the operating status before the Channel was recalled.
Changing the Band
To enable this product to memorize more Channels, they are stored in three bands: XM1,
XM2 and XM3.
• Switch bands.
XM1 = XM2 = XM3
Each press changes the Band ...
Selecting the Channel by Channel Number
When Channel Number Select mode is selected, you can select a desired Channel by
Channel Number. (Refer to “Switching the Channel Select Mode”.)
Initially, Channel Number Select mode is selected.
• Select a desired Channel.
Note:
• Channels that cannot currently be selected are skipped, and the next Channel is selected.
• If you continue pressing the button for longer than 0.5 seconds, you can increase/decrease Channel
Number by 10 to enable you to quickly jump to your desired Channel.
• You can also select a Channel from a desired Channel Category. (Refer to “Switching the Channel
Select Mode”.)
Preset Memory
Preset Memory lets you store Channels in memory.
1. Select a desired Channel to store in memory.
2. When sound from a selected Channel is output, press a button from 1–6 for 2
seconds to store that Channel. (e.g. Press button 4.)
The Channel is stored in the selected button.
Note:
• Memory/recall are for broadcasts. If you recall a memorized broadcast that has been moved to
another Channel, the Channel to which the broadcast was moved is selected.
Hold for 2 seconds
Reception status indicator