Network Router User Manual

Compact T1 - Release 6.1 5-83
CLI Commands
set
set local
Use the set local command to enable or disable local DIP switch settings. The LOCAL LED
on the Controller, will display an green light indicator if Local is set to ON.
Syntax: set local {on|off}
Example: set local off
{on|off}
Note: set local will not effect the ACO, ST, OPT or RST switches on the controller.
set login auth
Use the set login auth command to set the authentication method for controller logins, with
local database or external RADIUS servers. When set to RADIUS the controller will try the
RADIUS servers first, if no servers reply to the request, the controller will use its local database
of users to authenticate the login. A set login authentication to RADIUS will fail without a
minimum of 1 RADIUS server configured.
Syntax: set login auth {local|radius}
Example: set login auth radius
The example will set the login authentication process to RADIUS.
{local|radius}
set login support
Use the set login support command to enable/disable the internal login accounts for Customer
Support personnel for the Controller and Router cards (IP or CMG).
Syntax: set login support {disable|enable}
Example: set login support disable
The example will prohibit logins via Customer Support passwords.
{disable|enable}
on To configure the Compact T1 using the DIP switches.
off To configure using the Command Line Interface (CLI).
local Authenticate user logins via the controller database (Default).
radius Authenticate user logins via the external RADIUS servers.
disable Prohibit logins via Customer Support passwords.
enable Allow logins via Customer Support passwords.