User's Manual

Page 9

724-746-5500 | blackbox.com

Chapter 4: TL500A Program Registers

4. TL500A Program Registers

The TL500A has been designed to perform several operations that are integral to

the proper function of your total communications system. The operations are

controlled by programmable information that is stored in files called “registers.”

Each register contains enough memory to hold factory preset default values

and “custom” values that allow the TL500A to operate to your specifications.

The following is a short description of each register function, program capacity,

and factory preset default values.

This register controls eight features or operating modes performed by the

TL500A. Each “flag” or feature can be turned on/off and is programmed as a

string of bit information. Zero (0) denotes “off” and one (1) denotes “on.”

NOTE: When programming this register, you must enter all Flag (Bit) values.

The Mode Flags are factory preset to the following:

Flag Function Value Description

Flag 1 (Bit 7) Caller ID Store and

Forward

1 (on) CID will be captured when unit

answers. CID data will be sent

one time, after the first ring,

when a device port is

addressed.

Flag 2 (Bit 6) Fax Tone Detect to

Device 2

1 (on) If fax tone is detected, call will

be transferred to device 2.

Flag 3 (Bit 5) Night Watch Mode 0 (off) Allows calls to automatically be

transferred to the specified

port if not answered within a

certain number of rings.

Flag 4 (Bit 4) Additional Detect

Time

0 (off) Increases the time in which

tones can be detected before

ringing the default port by 4

seconds.

Flag 5 (Bit 3) Protected Hook

Flash

0 (off) For any KSU that does not

allow DTMF once a call is

answered.