User Manual

Page 13
877-877-2269 | BlackBox.com
Chapter 2: Overview
1 2 3 4 5 6 7 8 9 10
Figure 2-2. Back panel.
Table 2-2. Back panel components.
Number in
Figure 2-2
Component Description
1 Ethernet port Used for Ethernet passthrough to an HDBaseT
receiver.
2 RS-232
passthrough
Connects to an RS-232 controller or RS-232
controllable device to pass through an RS-232
command.
3 HDBaseT OUT
port
Connects to an HDBaseT receiver.
4 HDMI OUT port Connects to an HDMI display device.
5 AUDIO OUT Ports Connects to an audio output device such as an
amplifier, a speaker ,or an earphone for HDMI
audio de-embedding output.
6 Contact IN ports Connects to a keypad for input source switching.
No.1: Press this button to select VGA IN.
No.2: Press this button to select DP IN.
No.3: Press this button to select HDMI1 IN.
No.4: Press this button to select HDMI2 IN.
G: Connects to Ground.
7 Tally OUT ports Connects to LEDs on the keypad to indicate the
selected source.
8 Sink ports Connects to keypad to control the display device
power ON/OFF.
NOTE: The display devices must support CEC and
CEC is enabled.
9 RS-232 control Connects to a PC or a third-party control system to
control this device via API commands.
10 Power input Connect to a 12 VDC, 3-A power supply.