User`s manual

_____________________________________________________________________
724-746-5500 | blackbox.com Page 92
 Specify which Users will be allowed to use this connection. This should be the same Users who
were given Remote Desktop access privileges in the earlier step. Click Next.
 On the Network Connection screen select TCP/IP and click Properties.
 Select Specify TCP/IP addresses on the Incoming TCP/IP Properties screen, select TCP/IP.
Nominate a From: and a To: TCP/IP address, and click Next.
Note You can choose any TCP/IP addresses so long as they are addresses that are not used
anywhere else on your network. The From: address will be assigned to the Windows XP/2003
computer and the To: address will be used by the console server. For simplicity, use the IP
address as shown in the illustration above:
From: 169.134.13.1
To: 169.134.13.2
Or, you can set the advanced connection and access on the Windows computer to use the
console server defaults:
 Specify 10.233.111.254 as the From: address
 Select Allow calling computer to specify its own address
Also, you could use the console server default username and password when you set up the
new Remote Desktop User and gave this User permission to use the advance connection to
access the Windows computer:
 The console server default Username is portXX where XX is the serial port number on the
console server.
 The default Password is portXX
To use the defaults for a RDP connection to the serial port 2 on the console server, you would
have set up a Windows user named port02.
 When the PPP connection has been set up, a network icon will appear in the Windows task bar.