User`s manual

_____________________________________________________________________
724-746-5500 | blackbox.com Page 22
 You will be prompted to log in. Enter the default
administration username and administration
password:
Username: root
Password: default
Note Console servers are factory configured with HTTPS access enabled and HTTP access disabled.
A Welcome screen, which lists four initial installation configuration steps, will be displayed:
1. Change the default administration password on the System/Administration page (Chapter 3).
2. Configure the local network settings on the System/IP page (Chapter 3).
3. Configure port settings and enable ….. the Serial & Network/Serial Port page (Chapter 4).
4. Configure users with access to serial ports on the Serial & Network/Users page (Chapter 3).
After completing each of the above steps, you can return to the configuration list by clicking in the top
left corner of the screen on the Black Box logo.
Note If you are not able to connect to the Management Console at 192.168.0.1 or if the default
Username/Password were not accepted, then reset your console server (refer to Chapter 11).
3.2 Administrator Password
For security reasons, only the administrator user named root can initially log into your console server.
Only people who know the root password can access and reconfigure the console server itself. However,
anyone who correctly guesses the root password could gain access (and the default root password is
default). To avoid this, enter and confirm a new root password before giving the console server any
access to, or control of, your computers and network appliances.