User`s guide

BLACK BOX® CS Installation, Administration, and User’s Guide 53
Connect
Connect to CS
When you click the “Connect to CS” radio button on the “Connect” form, a
Java applet viewer appears running an SSH session on the CS. The following
figure shows the Java applet when you connect to the CS. Note in the
“Connected to” message in the below figure at the top of the screen the IP
address of the CS followed by the session type, in this case “SSH”.
Figure 3-4: Java Applet
The following table describes the available buttons in the Java applet:
Table 3-2: Java Applet Buttons
Button Purpose
To send a break to the terminal