User`s guide

Ports Menu & Forms
286
This is the first port number on the master, after the last port number on
the master.
4. Enter the “Local IP” address.
This is the IP address of the master.
5. Enter the “First Local TCP Port Number”.
This is the first TCP port number on the master, after the last port number
on the master.
6. Enter the “Remote IP” address.
This is the IP address of the slave.
7. Enter the “First Remote TCP Port Number”.
This is the first TCP port number of the slave. The default is 7001.
8. Select the communication protocol between the master and the slave from
the “Protocol” pull-down menu.
The options are Telnet or SSH.
T To Assign Names to Slave ports in the Cluster
Pressing the “Port Names” button on the New/Modify Port dialog box, brings
up the form shown in the following figure.