User`s guide

Ports Menu & Forms
252
4. To configure a terminal to automatically connect to CS, do the following
steps.
a. Select “Local Terminal” from the “Connection Protocol” pull-down
menu.
b. Define a terminal profile menu. “Terminal Profile Menu” form is at
Expert > Applications > Terminal Profile Menu.
5. To configure a terminal to automatically connect to a server, do the
following steps.
a. Select “Telnet”, “SSHv1”, “SSHv2”, or “Raw Socket” from the
“Connection Protocol” pull-down menu.
b. Specify authorized users/groups and the authentication method in the
“Access” form.
c. Specify the TCP Port number, the IP address of the remote host, and
the terminal type using the “Other” form. The “Other” form is located
at Ports > Physical Ports > Modify Selected Ports > Other.
6. If you are finished, click “Done.”
7. Click “apply changes.”
T To Configure a Serial Port Connection Protocol for an
External Modem
This procedure assumes that the selected serial port is physically connected to
an external modem.
1. Go to Ports > Physical Ports in Expert mode, select a port or ports to
modify, click the appropriate Modify Ports button.
The General form appears.
The port configuration section includes six forms in tabbed format as
shown in the following figure.
Figure 10-14: Expert > Ports > Physical Ports > Modem Connection Active
Tabs
2. Click the General tab.