User`s guide

Network Menu & Forms
166
2. Enter an IP address in the “Local IP” field, if desired.
By default, the IP address of the CS is used. Only change the IP address if
you have a specific reason to do so.
3. In the “Remote IP” field, specify the IP address to assign to the other end
of the PPP connection, if desired.
By default, the IP address 10.0.0.1 is assigned. Only change the IP
address if you have a specific reason to do so.
4. To enable call back, do the following:
a. Check the “Call Back” check box.
The “Phone Number” field appears on the Slot dialog box.
b. Enter a number for CS to use to call back modem.
5. Click OK.
6. Click “apply changes.”
Configuring a GSM PCMCIA Card
You can use the “PCMCIA Management” form under “Network” to enable a
remote user to call into the CS through an installed and configured GSM
PCMCIA card. When you select GSM from the pull-down menu, the dialog
box shown in the following figure appears.