User`s guide

Applications Menu & Forms
130
Figure 7-12: Expert > Applications > IPDU Power Mgmt. > Configuration
Note: The number of amps shown in the Master Unit (and Slave units if available)
pull-down menu varies according to the model of the connected PM. Figure 7-
12 shows number 15 for two 15 amp PMs as a Master and a Slave.
T To Specify Names, Alarms, Syslogging, and Over
Current Protection for IPDUs
Perform this procedure if you want to specify an alias or configure a threshold
current to trigger alarms, syslogging, or over-current protection for an IPDU.
1. Go to Applications > IPDU Power Mgmt. > Configuration.
2. The Configuration form displays entries for all ports configured for power
management. Perform the following steps for each IPDU.
a. Assign a name to the IPDU in the “Name” field, if desired.
b. For each AlterPath PM, click the appropriate check boxes to enable or
disable Over Current Protection, the generation of Syslog files, and
the sounding of a Buzzer.
All of the selected actions occur if a defined threshold is exceeded on
the IPDU.
c. If enabling over-current protection, a buzzer, or alarm notification,
select an Alarm Threshold from the pull-down menu.