User`s guide

BLACK BOX® CS Installation, Administration, and User’s Guide 125
Applications
configured for syslogging, an alarm buzzer, and over current protection. The
configuration is done through the IPDU Power Mgmt Configuration form.
The following table describes the information viewable on the “View IPDUs
Info” form. The information shown in the table appears for each serial port
that is configured for power management. For example, Figure 7-9 displays
“Serial Port 1: General Information” configured for power management.
Table 7-3: Expert > View IPDUs General Information
You can view the following information about each IPDU that is configured
through a serial port. For example, the configuration illustrated in Figure 7-9
there are two sets of data. Master Unit Information and Slave 1 Information.
There are two PM8 15A IPDUs are daisy-chained through Serial Port 1.
Description Example
Name
Either a default name or administrator-
configured name appears.
PM
Number of
Units
The number of IPDUs connected to the port.
The first IPDU is referred to as the master.
Any other IPDUs daisy-chained off the first
IPDU are referred to as slaves.
2 IPDUs daisy-chained
through the Serial Port 1
Number of
Outlets
Total number of outlets on all connected
IPDUs.
Sixteen for two
AlterPath PM8 15A
daisy-chained through
Serial Port 1
Buzzer
Whether a buzzer has been configured to
sound when a specified alarm threshold has
reached.
ON when the buzzer is
configured
Syslog
Whether syslogging has been configured for
messages from this IPDU.
ON when syslogging is
configured
Over Current
Protection
Whether over current protection is enabled.
“Over Current Protection” is to prevent
outlets from being turned on, if the current
on the IPDU exceeds the specified threshold.
OFF when over current
protection is not enabled