User`s guide

BLACK BOX® CS Installation, Administration, and User’s Guide 111
Description of Forms in Expert Mode
Virtual Ports
Perform Clustering. One CS can be
used as a Master to control other CS
(slaves) units. All ports of the slave
unit appear as if they are in the
master unit. This section shows how
to define and configure the slaves.
Chapter 10, Page 281
Port Status
View the current status of each port.
The information provided here are:
RS232 Signal Status and user
connected to each port.
Chapter 10, Page 287
Ports Statistics
View information on the data
reception Rx bytes and transmission
Tx bytes on each physical port. View
current CAS user(s), Baud rate,
frame, parity, break and overruns.
Chapter 10, Page 288
Table 6-6: Administration
Menu Selection Use this menu to: Where Documented
System Information
View
information on the system
hardware, version, file system
and PCMCIA cards loaded
Chapter 11, Page 292
Notifications
Configure the alarm strings and the
destination of the notification. CS
can send notification by email,
pager or SNMP trap in the
occurrence of any system warnings
and alarms.
Chapter 11, Page 295
Table 6-5: Expert > Ports
Menu Selection Use this menu to: Where Documented