User`s guide

BLACK BOX® CS Installation, Administration, and User’s Guide 87
Figure 5-7: Wizard > Step 2: Network Settings - DHCP enabled.
T To configure the Network Settings
1. Select “Step 2: Network Settings.”
The system brings up the DHCP form. By default DHCP is active.
Note: If DHCP is enabled, a local DHCP server assigns CS a dynamic IP address
that can change. The administrator chooses whether or not to use DHCP
during initial setup.
2. If you are using DHCP, proceed to “Step 3: Port Profile”, if not, click on
the checkbox to deselect DHCP and enter your network settings manually.
3. Enter the following network information:
•Host Name
• IP addresses
• Network Mask
• Domain Name
•DNS Server
• Gateway IP
4. Select “apply changes” to save configuration to flash.