User manual

Wizard DP Extender
724-746-5500 | blackbox.com
Page 30
3.2.12 Receiver link connections
Wizard DP Extender transmitter and receiver units are linked by either one or two CATx cables at a distance of up to 150 meters
(492 feet). The type and quality of the CATx cables used are crucial to the mode of operation (please see the section Tips for
achieving good quality links). If Hi-Speed USB is not needed at the receiver then a CATx link between the B ports of the units
is not required.
IMPORTANT: The signals sent through the link cables are NOT compatible with standard networking equipment and
could cause damage if connected. Do not connect the transmitter or receiver modules to any other networking devic-
es.
3.2.12.1 To link the units
1 Connect the CATx link cable from port A (on the front panel) of the transmitter unit to the LINK A port on the rear panel of
the receiver unit.
From link port
A on the
transmitter
unit
From link port B on
the transmitter unit
(required only for
transfer of
Hi-Speed USB)
2 If Hi-Speed USB is required, connect the CATx link cable from port B (on the front panel) of the transmitter unit to the LINK B
port on the rear panel of the receiver unit.