Specifications

REMOTE UNIT CONFIGURATION & OPERATION

Transferring DDC Information

To support non-standard screen settings or other features, it is possible to read and store DDC

information into the Local Unit directly from the monitors connected to the Remote Unit.

You only need to carry out this procedure once; the Extender Units store the DDC

information in non-volatile memory and restore it at power-up.

1. Ensure that you have installed and powered up the system according to the instructions

in Section 3.

2. Connect the monitor to the ‘monitor 1’ socket on the Remote Unit (see Figure 4).

3. Enter Command mode (see page 28).

4. If you want to apply the monitor’s DDC settings to BOTH video channels, continue to

step 6.

5. Select the video channel to which you want to apply the DDC settings (see page 30) by

pressing either <1> or <2>.

6. Press the key combination:

7. The DDC information is read from the monitor and applied to the selected video

channel(s) in the Local unit. This may take a few seconds. The Remote console

keyboard LEDs flash twice to indicate a successful transfer.

Always reboot Windows after adjusting a DDC parameter.