Specifications

REMOTE UNIT CONFIGURATION & OPERATION

4.3 Other Remote Configuration &

Operation Options

The ServSwitch Brand PS/2 KVM Micro Extender Series has additional commands to reset

the keyboard and mouse, to restore the factory default configuration, change DDC settings,

and to initiate and control a Private mode session (Dual Access models only).

Command Key Sequence

Reset Mouse and Keyboard <F1>

Resets the Remote console’s keyboard and mouse and then automatically exits Command

Mode. You may need to do this if you have hot-plugged a keyboard or mouse and it has not

initialized correctly.

Mouse Recovery <F3>

Use this command if you experience erratic movement of the mouse pointer or you have lost

mouse movement after hot plugging the Local unit into the CPU. In the case of erratic

mouse movement, you may need to enter the command a number of times to re-synchronize

the mouse signal. Alternatively, stop moving the mouse for a few seconds and the operating

system’s mouse drivers may automatically re-synchronize the signal. If the Local unit has

been hot-plugged, this command will issue a request to the OS to initialize the mouse. Use

this command with care.

Set Extender To Default State <Left Control> + <F9>

Sets ALL extender settings (video, configuration & DDC) back to the factory defaults and

then exits Command Mode.

Toggle Remote Unit Private Mode <Scroll Lock>

Use this command to begin or end a Private Mode session at the Remote console (see page

32).

Toggle Local Video Blanking State <Left Control> + <Scroll Lock>

Use this command to determine whether the Local console monitor will be blanked (default

setting) or enabled during a Private mode session at the Remote console.

Disable DDC Emulation <Left Control> + <F2>

By default, the Local unit provides DDC emulation on both video channels. Use this

command to disable DDC emulation (see page 32).

Enable DDC Emulation <F2>

Use this command to restore DDC emulation.

Transfer DDC to Local Unit <Left Control> + <D>

Read DDC from monitor connected to Remote Unit video channel 1 and apply to selected

video channels in Local Unit (see page 33).