Specifications

QUICK SETUP
11
1.1 Command Summary
By using a specific ‘hot’ key sequence, you can put the Remote console keyboard into a
Command Mode. From this, you can use various keys and key combinations to tune the video
signal and generally configure the extender system. The following table summarizes the ‘hot’
key command sequences used in system configuration and video tuning (see page 28).
Command Mode
Enter Command Mode*
Exit Command Mode & Save*
Exit Command Mode Without Save*
<Left Control> + <Left Shift> + <F10>
<ESC>
<Left Control> + <ESC>
Video Channel Selection
Select Channel For Adjustment
Select BOTH Video Channels
<1>, <2>
<0>
Reset Commands
Reset Mouse and Keyboard*
Mouse Recovery*
Set Extender To Default State*
<F1>
<F3>
<Left Control> + <F9>
Other Commands
Toggle Private Mode*
Toggle Video Blanking State at other console*
Disable DDC Emulation
Enable DDC Emulation
Transfer DDC from monitor to Local Unit
<Scroll Lock>
<Left Control> + <Scroll Lock>
<Left Control> + <F2>
<F2>
<Left Control> + <D>
* Commands also available at Local console in Dual Access Kits: ACU3209A and
ACU3228A (see page 34).