User guide

Chapter 3 - Additional Features
User Guide 83
Screen 7:
***********************************************************
*********CONFIGURATION WIZARD*********
************************************************************
Current configuration:
(The ones with the '#' means it's not activated.)
all.ipno : #
all.socket_port : 7001+
all.protocol : socket_server
all.users : #
all.poll_interval : #
all.tx_interval : #
all.idletimeout : #
conf.group : #
Are these configuration(s) all correct? (y/n) [n]:
If you type 'n':
Type 'c' to go back and CORRECT these parameters or 'q' to
QUIT :
Typing 'c' repeats the application, typing 'q' exits the entire wiz application.
If you type 'y':
Discard previous port-specific parameters? (y/n) [n] :
Type 'c' to CONTINUE to set these parameters for specific
ports or 'q' to QUIT :
Typing 'c' leads to Screen 8, typing 'q' leads to Screen 9.
Note: Answering yes to this question will discard only the parameter(s) which
you are currently configuring if they were configured for a specific port in a
previous session. For instance, if you are currently configuring parameter, all.x,
and there was a specific port, s2.x, configured; then, answering yes to this
question will discard s2.x.