User guide

Chapter 2 - Installation, Configuration, Usage
User Guide 61
While still in the DOS window, type the following and then press Enter:
telnet <IP assigned to the BLACK BOX ® Advanced Console
Server by DHCP or you> 7001
An example would be:
telnet 192.168.160.10 7001
If everything is configured correctly, a telnet session should open on the server
connected to port 1. If not, check the configuration, follow the above steps again,
and check Appendix E - Software Upgrades and Troubleshooting
.
Task 7: Save the changes
Execute the following command in HyperTerminal to save the configuration:
saveconf
Task 8: Reboot the BLACK BOX ® Advanced Console Server
After rebooting, the initial configuration is complete.
Note: restoreconf does the opposite of saveconf, copying the contents of the
/proc/flash/script file to the corresponding files in the ramdisk. The files on the
ramdisk are overwritten. Restoreconf is run automatically each time the
BLACK BOX ® Advanced Console Server is booted.