User guide

Chapter 3 - Additional Features
User Guide 243
If you type 'N'
Type 'c' to go back and CORRECT these parameters
or 'q' to QUIT :
Typing 'c' repeats the application, typing 'q' exits the entire wiz application
If you type 'Y'
Discard previous port-specific parameters? (y/n) [n] :
Type 'c' to CONTINUE to set these parameters for
specific ports or 'q' to QUIT :
Typing 'c' leads to Screen 6, typing 'q' leads to Screen 7.
Screen 6:
***********************************************************
*********CONFIGURATION WIZARD*********
***********************************************************
You have 8 available ports on this system.
Type 'q' to quit, a valid port number[1-8], or anything
else to refresh :
Note: Answering yes to this question will discard only the parameter(s) which
you are currently configuring if they were configured for a specific port in a
previous session. For instance, if you are currently configuring parameter, all.x,
and there was a specific port, s2.x, configured; then, answering yes to this
question will discard s2.x.
NOTE: The number of available ports depends on the system you are on. Typing
in a valid port number repeats this program except this time it's configuring for
the port number you have chosen. Typing 'q' leads to Screen 7.