User guide

Chapter 3 - Additional Features
User Guide 233
To configure parity:
configure line <serial port number> parity <string>
To configure flow:
config configure line <serial port number> flow <string>
To configure dcd:
config configure line <serial port number> dcd <number>
Step 2: Activate and Save.
To activate your new configurations and save them to flash, type:
config write
(This is essentially typing signal_ras hup and saveconf from the normal terminal
prompt.)
Configuration for Dial-in Access
Browser Method
See the browser method for the CAS, earlier in this section. The only difference for Dial-in is
that the “Dial-in Profile” button should be clicked in Step 5.
Tip. You can configure all the parameters for a serial port in one line:
config configure line <serial port number> tty <string>
speed <number> datasize <number> stopbits <number>
parity <string> flow <string> dcd <number>