User guide

Chapter 3 - Additional Features
User Guide 189
Step 1: Bring up the wizard.
At the command prompt, type the following to bring up the Help custom wizard
(you can also type wiz -h):
wiz --help
Help Command Line Interface Information
Synopsis 1 - Configuration of Port Specific Parameters
config configure line [serial port number] [options]
or in CLI mode:
configure line [serial port number] [options]
The following table shows Help CLI Options and the actual parameter modified for
Synopsis 1.
sl Configuration of syslog parameters
snf Configuration of sniffing parameters
sset <cas or ts> Configuration of serial setting parameters
tl Configuration of terminal login display parameters
tso Configuration of other parameters specific to the TS profile
Note: To enter into CLI mode, type config at the terminal prompt. You will
then get a CLI prompt similar to config@hostname>>. Once in CLI mode, you
eliminate the need to type config at the beginning of your CLI commands. To
exit from this mode, type exit or quit.
Table 10: General Options for the Help Wizard
Option Description