Installation manual

76
7. Click on the first line of Holder 1
8. Click on ‘Submit’
NOTE: The user may be requested to select a Disk Unit or to fill in the
originator information before the sample can be submitted.. Proceed to “B.
SAMPLE RUN” to start the automation.
5.1.2. Set up of two single experiments
1. Follow steps 1 through 5 of “5.1.1 Setup of one single experiment”
2. Click on ‘Add’
NOTE: To add one experiment, regardless if it is a single or coposite one, a
“1” should be displayed in the window next to the ‘Add’ button. A new line
opens up containing the same information for the Disk, Name, Solvent and
Orig/Title. The Exp No is incremented by 1.
3. Click on the small button to the right of the Experiment window and
select C13CPD32 by clicking on it