Installation manual

57
measured after all experiments on the current sample have been
completed.
• Do Priority Sample immediately: the priority sample is measured
after the current experiment on the current sample is completed.
4. Set the Modes accounted for by clicking on the gray box next to it
• Priority + Night/Day: the user has full control to use the priority
sample handling and Night/Day time option.
• Night/Day only: the user has control over Night/Day option only
• Priority only: the user can only use the priority sample handling
5. Set the Night / Day Switch-over time
NOTE: If samples have to be run during night time, the night beginning and
end times can be set using the 24 hour system. A switch is provided to enable
a nighttime experiment to be run during idle day time hours.
3.2.5. Temperature Handling
NOTE: This Menu is used to set and check the temperature before and after
the sample insertion and is valid only for Standard BACS, Manual Mode and
Sample Track Automation Systems. Define TE as a user specific parameter.
1. Click on “Temperature Handling”
2. Click inside the square next to “Temperature Handling (On/Off)”