Installation manual

2.3. Prosol and TUNE file set up

1. Type edprosol

NOTE: To follow the instruction below, the transmitter 90 deg. Pulse length

and power levels of the observe nuclei have to be known and entered in the

appropriate fields. If ATP was used to calibrate the probe, those parameters

were automatically entered. If the transmitter 90 deg. Pulse length and

power levels are not known, then use the instructions in Chapter 3,

Optimizing Parameters, to measure them. It is a good practice to use this

chapter to measure the exact pulse length and power levels. Choose only

those nuclei which can be observed on the current probe.

2. Select logical channel ‘F1 + F2’ by clicking on it

3. Select ‘Standard hard pulses’ by clicking on it

4. Select Probe name: ‘current’

5. Select solvents: ‘all’