Setup guide

4-29
Installation and Setup Guide for Cisco Secure ACS Appliance
78-14573-02
Chapter 4 Administering the Cisco Secure ACS Appliance
Reconfiguring Appliance System Parameters
Result: The system displays the following message on the console:
Current Date Time Setting:
Time Zone: (GMT -xx:xx) XXX Time
Date and Time: mm/dd/yyyy hh/mm/ss
NTP Servers: (“Ntp Synchronization Disabled” - or -a list of NTP
servers)
Change Date & Time Setting? [N]
Step 3 To set the time zone, time, or date type Y, and then press Enter.
Result: The system displays a list of indexed time zones and the following
message:
[xx] (GMT -xx:xx) XXX Time.
Enter desired time zone index (0 for more choices) [x]:
Step 4 Enter the desired time zone index number from the time zone setting list, and then
press Enter.
Tip You can also type 0 (zero) and press Enter to see more time zone index numbers.
Result: The system displays the new time zone.
Step 5 At the Synchronize with NTP Server? prompt, type N, and then press Enter.
Step 6 At the Enter date [mm/dd/yyyy]: prompt, type the date, and then press Enter.
Step 7 At the Enter time [hh:mm:ss]: prompt, type the current time, and then press
Enter.
Result: The system time is reset.
Setting the System Time and Date with NTP
You can set and maintain the system date and time using either of two methods:
• Set the time and date manually.
• Assign a network time protocol (NTP) server with which the system
synchronizes its date and time.