Setup guide

4-27
Installation and Setup Guide for Cisco Secure ACS Appliance
78-14573-02
Chapter 4 Administering the Cisco Secure ACS Appliance
Reconfiguring Appliance System Parameters
To reconfigure the IP address, follow these steps:
Step 1 Log on to the Cisco Secure ACS Appliance. For more information, see Logging
On to the Appliance via Serial Console, page 4-2.
Step 2 Type set ip, and then press Enter.
Step 3 At the Use Static IP Address [Y]: prompt, type Y for yes or N for No, and then
press Enter.
Step 4 If you answered No to using a static IP address, the system displays a
confirmation of DHCP and the message
IP Address is reconfigured. Continue
the procedure with Step 5.
If you responded Yes in the previous step to use a static IP address, do the
following:
a. To specify the Cisco Secure ACS Appliance IP address, at the IP Address
[xx.xx.xx.xx]:
prompt, type the IP address, and then press Enter.
b. At the Subnet Mask [xx.xx.xx.xx]: prompt, type the subnet mask, and then
press Enter.
c. At the Default Gateway [xx.xx.xx.xx]: prompt, type the default gateway,
and then press Enter.
d. At the DNS Servers [xx.xx.xx.xx]: prompt, type the address of any DNS
servers you intend to use (separate each by a single space), and then press
Enter.
Result: The system displays the new configuration information and the
following message:
IP Address is reconfigured.
Step 5 Review the information presented and, at the Confirm the changes? [Y]:
prompt, press Enter.
Result: The Cisco Secure ACS Appliance restarts. The system displays the
following message:
New ip address is set.
Step 6 At the prompt, Test network connectivity [Yes]:, type Y, and then press
Enter.