Setup guide

Chapter 4 Administering the Cisco Secure ACS Appliance
Reconfiguring Appliance System Parameters
4-26
Installation and Setup Guide for Cisco Secure ACS Appliance
78-14573-02
To reset the Cisco Secure ACS Appliance administrator name, follow these steps:
Step 1 Log on to the Cisco Secure ACS Appliance. For more information, see Logging
On to the Appliance via Serial Console, page 4-2.
Step 2 At the system prompt, type set admin, and then press Enter.
Result: The Cisco Secure ACS Appliance displays the
Set administrator’s
name
prompt.
Step 3 Type the new administrator name, and then press Enter.
Step 4 At the Set administrator name again prompt, type the administrator name
again and then press Enter.
Result: The system displays the following message on the console:
Administrator name is set successfully.
Reconfiguring the Appliance IP Address
Typically, you configure the IP address only once, during initial configuration.
See Configuring the Cisco Secure ACS Appliance, page 3-15.
Caution Reconfiguring the IP address may cause other network devices to fail to recognize
the Cisco Secure ACS Appliance.
Caution Reconfiguring the IP address causes services to restart. AAA services to users
will be interrupted.
Note To set or change the IP address of your Cisco Secure ACS Appliance, it must be
connected to a working Ethernet connection.