Setup guide

4-9
Installation and Setup Guide for Cisco Secure ACS Appliance
78-14573-02
Chapter 4 Administering the Cisco Secure ACS Appliance
Basic Command Line Administration Tasks
Restarting Appliance Services via Serial Console
Note Restarting appliance services is a procedure that is typically performed from
within the HTML interface.
You can restart any Cisco Secure ACS Appliance service from the serial console.
Cisco Secure ACS Appliance services include the following:
• CSAdmin
• CSAuth
• CSDbSync
• CSLog
• CSMon
• CSRadius
• CSTacacs
Tip To list the services and their status, you can use the show command. For more
information, see Determining the Status of Appliance System and Services via
Serial Console, page 4-4.
To restart an ACS service, follow these steps:
Step 1 Log on to the Cisco Secure ACS Appliance. For more information, see Logging
On to the Appliance via Serial Console, page 4-2.
Step 2 Type restart followed by a single space and the name of the ACS service you
want to restart.
Tip You can list more than one service to restart; type a single space between each.