Setup guide

3-19
Installation and Setup Guide for Cisco Secure ACS Appliance
78-14573-02
Chapter 3 Installing and Configuring the Cisco Secure ACS Appliance
Initial Configuration
e. At the prompt, Confirm the changes? [Yes]: type Y, and then press Enter.
Result: The system displays the following message:
New ip address is set.
Default gateway is set to xx.xx.xx.xx
DNS servers are set to: xx.xx.xx.xx xx.xx.xx.xx.
f. At the prompt, Test network connectivity [Yes]:, type Y, and then press
Enter.
Tip This step is essentially executing a ping command to ensure the connectivity of
the Cisco Secure ACS Appliance.
g. At the prompt, Enter hostname or IP address:, type the IP address or
hostname of a device connected to the Cisco Secure ACS Appliance, and then
press Enter.
Result: If successful, the system displays the ping statistics. The system
displays the prompt:
Test network connectivity [Yes]:.
h. If network connectivity is proven okay in the previous two steps, at the
prompt,
Test network connectivity [Yes]:, type N, and then press Enter.
Tip The system continues to provide you with the opportunity to test network
connectivity until you answer no. This gives you an opportunity, if required, to
correct network connections or retype the IP address.
Step 12 If the settings have been correctly displayed, at the prompt, Accept network
setting [Yes]:
, type Y, and then press Enter.
Result: The system displays the following message on the console:
Current Date Time Setting:
Time Zone: (GMT -xx:xx) XXX Time
Date and Time: mm/dd/yyyy
NTP Server(s): NTP Synchronization Disabled.
Step 13 To set the time and date of the Cisco Secure ACS Appliance, at the Change Date
& Time Setting [N]:
prompt, type Y, and then press Enter.
Result: The system displays a numbered list of time zones.