Setup guide

Chapter 3 Installing and Configuring the Cisco Secure ACS Appliance
Initial Configuration
3-18
Installation and Setup Guide for Cisco Secure ACS Appliance
78-14573-02
Note To set or change the IP address of your Cisco Secure ACS Appliance, it
must be connected to a working Ethernet connection.
Note A static IP address must be assigned to your Cisco Secure ACS
Appliance. You can set the IP address directly by answering Y to this step
and performing the substeps detailed in Step 11. Alternatively, you may
use a DHCP server if it assigns a single IP address that does not change.
Step 11 The following prompts appear only if you set a static IP address manually.
Otherwise the following message appears:
No change to the configuration.
Accept network setting [Yes]
a. To specify the Cisco Secure ACS Appliance IP address, at the IP Address
[xx.xx.xx.xx]:
prompt, type the IP address, and then press Enter.
b. At the Subnet Mask [xx.xx.xx.xx]: prompt, type the subnet mask value,
and then press Enter.
c. At the Default Gateway [xx.xx.xx.xx]: prompt, type the default gateway
value, and then press Enter.
d. At the DNS Servers [xx.xx.xx.xx]: prompt, type the address of any DNS
servers you intend to use (separate each by a single space), and then press
Enter.
Note If you do not intend to use a DNS server, enter the IP address of the
Cisco Secure ACS Appliance at the
DNS Servers [xx.xx.xx.xx]:
prompt. If you do not configure the Cisco Secure ACS Appliance to
use a DNS server, you must respond to all prompts for “
hostname or
IP address” only with an IP address.
Result: The system displays the new configuration information followed by
the following message:
IP Address is reconfigured.